CW-C180BN
– 9 –
°C
1. Power Supply
Set the Main Control Knob to the “ ” OFF
position; confirm that the power supply cord is
connected to a proper AC outlet.
32 23 43 26
21 15 21 15
Recommended
Use the air conditioner under
the following conditions:
• Operating temperature range.
(unit in °C)
Indoor unit Outdoor unit
D.B.T. W.B.T. D.B.T. W.B.T.
Maximum
Temperature
Minimum
Temperature
Maximum
Temperature
Minimum
Temperature
D.B.T.: Dry Bulb Temperature
W.B.T.: Wet Bulb Temperature
• Humidity does not exceed 90%.
Continuous operation at over 90% humidity
may create condensation and waterdrops on
the intake and outlet vents.
HEATING
COOLING
27 – 21 15
20 – -5 -6
2. Open the
cover
3. Main Control Knob
Set to either “ ” LOW COOL or “ ” HIGH
COOL and “ ” LOW HEAT or “ ” HIGH
HEAT as required.
(FAN setting operates the fan only.)
* Caution: If the Main Control Knob is turned
off or changed to a fan setting from a cooling
or heating operation setting, WAIT at least 3
minutes before resetting to a cooling or
heating operation.
4. Thermostat Control Knob
Set the Thermostat Control Knob to the desired
setting. (Usually “ ~ ” (Red) is a
recommended setting for heating and “ ~ ”
(Blue) for cooling.) If the room temperature is
unsatisfactory after a reasonable amount of
time, turn the control knob clockwise or anti-
clockwise to make the room cooler or warmer.
• When the Thermostat Control Knob is set to
“ ” (Blue), moisture may freeze onto the coils
and prevent effective cooling. If this happens,
turn the knob to “ ” (Gray) FAN, and the
thermostat control knob anticlockwise. This will
quickly defrost the cooling coil so that normal
cooling can be resumed.
5. Air Swing Switch
(Airflow direction adjustment
Side-to-Side)
For fixed side-to-side air direction, set the Air
Swing Switch to “ ” ON until the desired air
direction is obtained, then move it to “
” OFF.
For continuous side-to-side air circulation, set
the Air Swing Switch to “ ” ON and leave it
there.
HOW TO OPERATE
CW-A180BN, CW-A240SN (Cooling & Heating)