Panasonic CW-XC100VK - Page 12

9.5. Fan Speed Control
•
Manual Fan Speed Control
Basic fan speed adjustment (2 setting, from Lo to Hi) can be carried out by using the Fan Speed Selection Button/Pad at the
Remote Control or Main Unit (Touch Control Panel).
9.6. Airflow Direction Control
9.6.1. Horizontal Airflow Direction
When Air Swing Button/Pad is pressed with Remote Control
or Main Unit (Touch Control Panel) in the Auto Airflow, the
airflow direction louver swings side to side within the full swing
range as shown in the “Diagram”.
The louver can be adjusted by pressing the Button/Pad again
at the Remote Control or Main Unit (Touch Control Panel) to
the desired louver position.
When stopped with Remote Control or Main Unit (Touch
Control Panel), the louver vane is reset, and stopped at the
closing position.
“Diagram”
9.6.2. Vertical Airflow Direction
•
The upward and downward airflow direction vane can be adjusted manually by hand.
9.7. Remote Control Signal Receiving Sound
•
To switch off the beep sound.
Press the “Operation OFF/ON Pad” at the main unit continuously for 10 second or more.
Repeat the above if you want to switch ON the “beep” sound.
*However, if the “Operation OFF/ON Pad” have been pressed, the previous operation mode will be activated. If you do not
require this operation, you may change it by using the Main Unit (Touch Control Panel).
12
CW-XC100VK / CW-XC120VK