Panasonic CYCLONIC INVERTER NN-SN76LS - Initial Operation; First Time Use and Setup; Child Safety Lock

11
Operation
Using the Microwave
for the First Time
Setting the Clock Setting the Child
Safety Lock
1
Display Window
Plug into a properly grounded
electrical outlet.
2
Press Start once, then Press
Timer (More) to cycle between
the weight system, Imperial
(oz/lb) or Metric (g/kg).
3
Press Start once, then Press
Timer (More) to cycle between
the Beep on or Beep off.
4
Press Stop/Reset to confirm;
a colon (:) will appear in the
display window.
NOTES:
These choices can be selected
only when you plug-in the
oven.
1
With the oven NOT cooking,
press Clock (Less) once; the
colon will blink. Enter time of
day using the Number pads.
2
Press Clock (Less) to finish
setting and the colon (:) will
stop blinking.
NOTES:
1. To reset the clock, repeat
steps.
2. The clock will retain the
time of day as long as the
oven is plugged in and
electricity is supplied.
3. The clock is a 12-hour
display.
4. Oven will not operate while
colon (:) is flashing.
1
When the time of day appears
in the display, press Start three
times; “ ” will appear in the
display.
2
Press Stop/Reset three times;
the display will return to the
time of the day and Child
Safety Lock will be cancelled.
NOTES:
1. This feature prevents the
electronic operation of the
oven until cancelled. It does
not lock the door.
2. To set or cancel Child Safety
Lock, Start or Stop/Reset
pad must be pressed
3 times within 10 seconds.
3. You can set Child Safety
Lock feature when the
display shows a colon or
time of day.
F0003CK20AP_EN.indd 11F0003CK20AP_EN.indd 11 2020/2/26 9:51:052020/2/26 9:51:05