7-13
7
Item code Item Description
10 Unit type
Set when the indoor unit EEPROM memory is replaced during servicing.
11 Indoor unit capacity
12
System (outdoor unit)
address
These are not set at the time of shipping from the factory.
These must be set after installation if automatic address setting is not
performed.
13 Indoor unit address
14 Group address
17
Cooling intake
temperature shift
Shifts the intake temperature during cooling and dry operation.
(Enabled only when the body thermostat is used.)
Increase this value when it is difficult to turn the thermostat ON.
18
Automatic stop time after
operation start
The time at which an indoor unit is automatically stopped after operation
starts can be set in increments of 5 minutes
1b
Forced thermostat ON
time
Use this setting to change the time for forced operation at installation
or servicing from 5 minutes to 4 minutes.
(Enabled only with PAC models.)
1E
Temperature shift for
cooling/heating change in
āauto heat/coolā mode
āAuto heat/coolā selects the operating mode automatically based on the
difference between the room temperature and the temperature set on
the remote controller. This setting establishes a shift temperature for
the heating/cooling temperature setting relative to the remote controller
temperature setting.
Cooling temperature setting
Heating temperature setting
Remote controller temperature setting
Shift temperature
Shift temperature
7-6. Detaild Setting Items
Cooling temperature setting
Remote controller temperature
setting
Heating temperature setting
Shift temperature
Shift temperature
Sec7.inddīīī11 2012/02/28īīī15:07:26
SM830231-02īSingleī꬧å·.indbīīī13SM830231-02īSingleī꬧å·.indbīīī13 2014/09/09īīī21:19:302014/09/09īīī21:19:30
To Next Page
Loading...
Need help?
General
