EN-4
2. NAMES AND OPERATIONS (Continued)
B
A
C
D
E
I
H
F
G
A: This is displayed to indicate that the system controller is being used for control.
When indicator is ashing on the display, the operation is not accepted by the system
controller.
B: When the unit is in the heating standby mode, the
indicator appears.
C: This displays the temperature setting.
D: This displays alarm messages when an error occurs.
E: This is displayed when using the temperature sensor in the remote controller.
F: This is displayed only if an abnormality occurs within a unit.
G: The currently selected FAN SPEED is displayed.
H: When the TEST button is pressed, the TEST indicator appears.
I: The currently selected operation mode is displayed.
To Previous Page
Loading...
