7
Screen display
1 Appears when ECONAVI is being set
to ON.
2 Indicates the set temperature.
3 Appears when nanoe™ X is being set
to ON.
4 Displays the present time.
5 Timer program indication
: The indoor unit starts operation
at the programmed time.
: The indoor unit stops operation
at the programmed time.
6 Indicates the remote controller
addresses are set.
7 Appears when the function is not
available.
8 The ON timer or the OFF timer will
operate repeatedly every day.
9 Indicates the ap position.
10
Indicates the fan speed.
11 Displays the selected operation
mode. (AUTO
/HEAT /DRY /
COOL
/FAN )
12
Energy saving operation is in process.
13 Appears when a fan available in the
market is installed and is operating.
14 “Temperature Automatic Return” is
set.
15 Appears when the setting screen is
displayed.
8
9
1. Receiver
Receives the signal sent from the
remote controller.
2. Emergency operation button
Indicator lamps
When an error occurs, one of the
lamps ashes. When an indicator
lamp is ashing, refer to the operating
instructions.
3. OPERATION lamp
Lights up when the unit is operating.
4. TIMER lamp
Lights up when the timer is set.
5. STANDBY lamp
The lamp in the HEAT mode lights up
at the following times: during the
startup, during the thermostat
operation, and during the defrosting.
6. FILTER lamp
This lamp is for notifying you when
the filter needs to be cleaned.
CZ-RWS3_QRG.indd 7 2018/05/30 10:34:06
To Next Page
Loading...
