Panasonic CZ-RWSK2 - Setting Indoor Unit Addresses (CZ-RWSK2)

EN-18
Note
• The Test Run/On and Test/On switches are for use when the unit is installed and test run. It is not for normal
use.
• If the [Normal/Stop ALL] switch is on
Stop ALL, the unit cannot receive signals from the remote control.
CZ-RWSC2/CZ-RWSL2
1. Press [Emergency Operation] of the receiver.
If the indoor temperature is 24 °C or greater when the unit starts running, it will act as a cooler.
If the indoor temperature is less than 24 °C when the unit starts running, it will act as a heater.
2. If you press , the wind direction automatically oscillates up and down.
Stop: press [Emergency Operation]
of the receiver again.
21
CZ-RWSL2 CZ-RWSC2
1
2
Note
• The Test Run/On and Test/On switches are for use when the unit is installed and test run. It is not for normal
use.
• If the [Normal/Stop ALL] switch is on
Stop ALL, the unit cannot receive signals from the remote control.
12. Emergency Operation (Cont.)
Instructionhonbunall.indbEN-18Instructionhonbunall.indbEN-18 2012/09/1212:39:152012/09/1212:39:15