Panasonic CZ-RWSK2

20
(EN)
Wireless
remote
controller
address
display
•••••
Address
switch
position
Address Address Address Address Address Address Address
ALL
1234
5
6
Receiving is
possible at all
address
positions
䠍䠎䠏䠐
㻻㻲㻲
㻻㻺
䠍䠎䠏䠐
㻻㻲㻲
㻻㻺
䠍䠎䠏䠐
㻻㻲㻲
㻻㻺
䠍䠎䠏䠐
㻻㻲㻲
㻻㻺
䠍䠎䠏䠐
㻻㻲㻲
㻻㻺
䠍䠎䠏䠐
㻻㻲㻲
㻻㻺
Setting Addresses (CZ-RWSK2)
(Setting the address of the indoor unit)
1. Set the address for the remote controller following the
procedure under the section “Setting Remote Controller
Addresses” (see page 19).
2. Press [Emergency Operation]
of the indoor unit for four
seconds or longer.
When you do this, the lamps of the display will blink one after another.
3. Press on the remote controller.
4. The buzzer will sound and the address of the indoor unit will
change to the address displayed on the remote controller.
5. If you press [Emergency Operation]
of the indoor unit once,
the lamps on the indoor unit’s display will turn off.
Notes
• Please do not hold the [Emergency Operation] button of the indoor unit down
while the indoor unit’s display lamps are blinking one after another.
• Make sure to operate while the indoor unit is stopped.
• The address of indoor unit is set to "ALL" at the time of the shipment.
11. Addresses (Cont.)
ON
OFF
Interruptor
ON/OFF