file:///C|/U...LLSVC_DSC1703003CE/viewing/SGML_VIEW_DATA/ALL/DC-GH5P/SVC/DSC1703003CE/doc/DSC1703003CE_03.xml[11/12/2018 4:23:13 PM]
By inputting second line to third line of these data into the adjustment software and writing these data to Flash-ROM (IC2003), the shutter
adjustment becomes needless.
In addition, the adjustment software can read data encoded to QR Code by using WEB camera with a close-up function.
Refer to the adjustment instruction in the adjustment software for details.
3.3.1.3 About Main P.C.B. (Ref.1) & Flash-ROM (IC2003)
Important:
When cannot be repaired in the IC exchange, and in the case of performing the “Main P.C.B.” exchange,
carry out any of following.
In the case of exchanging the Flash-ROM (IC2003) is same way too.
1. When the camera power can be ON, and camera body and adjustment software can be communicated:
Before replacing the “Main P.C.B. and/or Flash-ROM”, proceed the EEPROM data backup from the unit.
then proceed the adjustment /inspection. (Almost adjustment/inspection items can be omitted.)
Refer to the adjustment instruction in the adjustment software for details.
2. When the camera power cannot be ON, or camera body and adjustment software cannot be communicated:
Almost full adjustment/inspection must be performed after replacing the “Main P.C.B. and/or Flash-ROM”.
Refer to the adjustment instruction in the adjustment software for details.
Notes after replacement:
3.3.1.4 About Venus Engine (IC2001) [Located on the Main P.C.B.]:
(The so called, “Package On Package” type IC.)
NOTE:
During servicing, do not press down hard on the surface of IC2001.
3.3.2 Lens Unit (Interchangeable Lens: H-FS12060)
3.3.2.1 About Lens Main Unit (Ref. 206)
1.
adjustments.
2.
maintain Serial number of owner’s original lens.
To Next Page
Loading...
