DIGITAL SIGNAL PROCESSORS
Pattern Type
Make contact type, No. of control patterns: 12 + MUTE
Control Anti-reverse diode provided
Connector D-SUB 15-pin, setscrew M2.6
Recommended connectors
Male: OMRON XM2A-1509 or equivalent
Hood: OMRON XM2S-1511 or equivalent
Power Supply AC220-240V 50/60Hz
Power Consumption
19 W (as defined in the Electrical Appliances Control Act)
Heat Flow 1
9 W (15 kcal)* The figure in parentheses is calorific value per hour.
Stacking Conditions 2 units high maximum
* If you are using 3 units or more, leave a space for a unit or more every 2 units.
Dimensions 480 (W) x 44 (H) x 280 (D) mm (without rubber feet)
Weight (approx.) 4.5 kg
Note: "RAMSA-NET" is a protocol exclusive to Matsushita Communication Industrial Co., Ltd.,
used to send and receive data between the host computer and two or more audio control units
connected to it with communication lines.
General Frequency Response 20 to 20,000 Hz, +0.5, –1.0 dB
Dynamic Range Analog input/output (typ, IHF-A)
115 dB (noise gate ON)
109 dB (noise gate OFF)
THD
0.015% at +4 dB, 20 to 20,000 Hz, 30 kHz LPF (at 600Ω load)
Crosstalk –70 dB or less (10 kHz)
User Memory No. of memories: 16
External Type RS-485 RAMSA-NET (See Note.)
Control Connector D-SUB 9-pin, IN/OUT 1 each, setscrew M2.6
Recommended connectors
Male: OMRON XM2A-0901 or equivalent
Female: OMRON XM2D-0901 or equivalent
Hood: OMRON XM2S-0911 or equivalent
Digital Multi Processor
WZ-DM35NH
•
2 inputs and 4 outputs.
•
6 functions: Graphic equalizer function, parametric
equalizer function, delay function, crossover network
function, compressor/limiter function, and noise gate
function.
•
6 Basic Modes: Three delay modes for sense-of-direction
control (DELAY1 to DELAY3) and three crossover
network modes (X-OVER1 to X-OVER3)
•
Built-in digital audio interface and conforms to the
AES/EBU format.
•
24-bit A/D and D/A converters are employed for analog
inputs and outputs to offer a dynamic range close to that
of an analog device.
•
All settings can be saved in up to 16 patterns in the
memory.
SPECIFICATIONS
Rear Panel
Dimensions
GEQ CH PEQ X-OVER LEVEL DELAY UTILITY
Model No. WZ-DM35NH
Input No. of Channels 2 ch
Analog
Type Electronic balance
Rated Input +4 dB
Maximum Input +24 dB or more
Connector XLR-3-31 or equivalent, 2 connectors
Input Impedance 20 kΩ
In-Phase Reject Ratio 40 dB or more
A/D Converter 24-bit ∆-∑ type
Digital
Type AES/EBU format, for professional use
Sampling Frequency 48 kHz±0.1%
Connector XLR-3-31 or equivalent, 1 connector
Output No. of Channels 4 ch
Analog
Type Electronic balance
Rated Output +4 dB±1 dB
Maximum Output +24 dB or more (at 10 kΩ load)
Output Impedance 150Ω
Connector XLR-type connector or equivalent, x4
Applicable Load Impedance
600Ω or more
D/A Converter 24-bit ∆-∑ type
Digital
Type AES/EBU format, for professional use
Sampling Frequency 48 kHz
Connector XLR-3-31 or equivalent, 1 connector
(Recommended cable: Canare Electric DA206 or equivalent)
PUBLIC ADDRESSRAMSA
Need help?
General