Source (Playing)
Pa mcorder
-Before you begin
• Connect both Palmcorder and VCR to
their power sources.
• Connect the Palmcorder to a VCR as
illustrated left.
• Turn ON both units.
• Set the recording VCR's Input Signal
Selector to LINE.
• Set the Palmcorder POWER to VCR.
-- AN Cable
(Supplied)
To Audio In
-4
To Video In
(To VI
--VHF Connecting
Cable (not
supplied)
Recording:
VCR (Rear)
Audio In Video In
/
J
Insert a pre-recorded tape
into the source (playing) Palmcorder
and a blank tape, with record tab in
place, into the target VCR (Recorder).
Press • (PLAY) on the Palmcorder.
When the tape reaches the point you
want to start dubbing, press PAUSE.
Place the VCR into REC/PAUSE
mode. (See VCR manual.)
Simultaneously, press PAUSE on
both units to begin copying.
Press STOP on both units when
copying is completed.
• For technical reasons, dubbing a tape
may reduce its quality.
• If the Time Code is displayed in the EVF
or LCD monitor, it cannot be reset.
• Only the DATE/TIME, when displayed,
will be recorded on the tape.
[IT_r_]_ (o) diviv|I_11i IMLo] l IiI IL_
• Turn the TV ON and select its VCR
channel (either CH3 or CH4).
• Set the VCR/TV Selector on the
recording VCR to VCR.
_bUoCAUTION:
nauthorized exchanging and/or |
pying of copyrighted recordings may
I
copyright infringement.
To Next Page
Loading...
