36
3 Open the LCD Monitor or the Viewfi nder.
• The Red Lamp lights up and the camera will be
put into recording pause approx. 1.7 seconds
after it is turned on.
To Cancel the Quick Start
Set [ SETUP] >> [ QUICK START] >> [OFF].
• If the standby continues for approx. 30 minutes,
then the Lamp (Green) will go off and the
Camcorder will be completely turned off.
2 While the [OFF/ON] Switch is still set to
[ON], close the LCD Monitor and retract
the Viewfi nder.
• The Green Lamp
1
lights up and the unit goes
into Quick Start Standby mode.
Notes:
• When you set [ POWER SAVE] to [5 MINUTES]
and the Camcorder is left in the Recording Pause
Mode for 5 minutes, the unit will turn off. (Green
LED will lit up.) Close the LCD Monitor and retract
the Viewfinder. To turn the Camcorder on open the
LCD Monitor and/or the Viewfinder.
• If the Mode Dial is moved or the battery is removed
in Quick Start standby mode, Quick Start is
canceled and the power turns off even if the [OFF/
ON] Switch is set to [OFF]. (However, changing the
mode between Tape Recording Mode and Card
Recording Mode will not cancel Quick Start.)
• When the Camcorder is Quick-Started with the
White Balance on automatic, it may take some time
until the White Balance is adjusted if the scene
being recorded has a light source different from the
scene last recorded. (When the MagicPix Function
is used, however, the White Balance of the scene
last recorded is retained.)
• If the power is turned on in Quick Start standby, the
zoom magnification becomes 5× and the picture
size may differ from what it was before Quick Start
standby.
• When using the AC Adaptor, Quick Start can be
used even if a tape is not inserted.
1
Self-timer Recording
(For PV-GS39/PV-GS69)
When you set the self-timer, the recording starts
automatically after 10 seconds on the Card.
• Set to Card Recording Mode.
1 Press the Joystick Control to display the
One-Touch Navigation icon on the lower
right of the screen.
2 Move the Joystick Control [▼] until the
page with [ ] indication is displayed.
1/2 NEXT
[One-Touch Navigation icon]
• The [ ] Indication flashes and the recording
starts after 10 seconds. After recording, the
Self-Timer will be canceled.
To Stop the Self-timer in Progress
Press the [MENU] Button.
Notes:
• When [ BEEP SOUND] on the [ SETUP]
Sub-Menu is set to [ON], the beep sound will be
emitted along with the Recording Lamp flashing in
the Self-timer Standby Mode.
• By operating the [OFF/ON] Switch or Mode Dial,
the Self-timer Standby Mode is canceled.
• If the RapidFire Consecutive Photoshot is set, the
maximum recordable pictures (max. 10 pictures)
are recorded. (p. 34)
3 Move the Joystick Control [◄] to select
[ ].
• The [SELF-TIMER ON] and the [ ] Indication
appears.
4 Press the [PHOTO SHOT] Button.
To Cancel the Self-timer
Move the Joystick Control [◄] to select [ ] again.
• The [SELF-TIMER OFF] is displayed.
To Next Page
Loading...
