Panasonic DMP-BD60GN - Page 22

22
7.2.2.2. Analysis Procedures
1. Confirmation of pointed symptom -1
• Confirm the pointed symptom of BD player occurs again after cleaning the lens.
2. Replacement of Digital P.C.B. with the normal P.C.B.
• Replace the failed Digital P.C.B. with the normal P.C.B.
3. Confirmation of pointed symptom -2
• Checking symptoms of failed disc in the procedure 1.
For this time,
PASS denotes the Digital P.C.B. is defective.
FAIL denotes the Optical Pick-up or mechanism are defective.
4. Replacement of Digital P.C.B. with the original one.
5. Pointed symptom -3
• Recheck the pointed symptoms to see mechanism part is improved.
For this time,
In case of FAIL, go back to Replacement failure part 1 to confirm the pointed symptoms.
If it is PASS, it is finished.
7.2.3. In the Case of Necessity the Adjustment
1. When the BD Drive is replaced.
2. When the Digital P.C.B. is replaced.
3. When the specific parts of Digital P.C.B. is replaced. (refer to below table.)
Note:
• Exchange it with Digital P.C.B. unit at a while when the exchange of IC51001 or IC51301 is necessary.
• When replacing only IC51601(EEPROM) and Digital P.C.B, use the Serial Remote function of "DIGA Support Nabi" and
change the model.
7.2.4. List of Service Tools
7.2.4.1. Adjustment / Inspection Tools
7.2.4.2. Commercial Tools Required
Replaced parts Adjustment item
Product name Part No. LPC adjustment Servo/signal adjustment
Digital P.C.B. IC51001 (BP1/FEP) RFKB76186E (BD60) Yes Yes
RFKB76186F (BD80) Yes Yes
IC51301 (NAND FROM) RFKB76186E (BD60) Yes Yes
RFKB76186F (BD80) Yes Yes
IC55005 (Motor DRIVER) AN41213A-VF Yes Yes
No. Category Part name Part No. Compatibility
1 Instrumention tool Serial cable RFKZ0139
2 Disc BD-ROM test disc (VFF0396) RFKZ0514
3 DVD-RAM test disc (X5RAM-BPS) RFKZ0515
4 CD-ROM test disc (CD-ROM-B01) RFKZ0516
No. Category Part name Part No. Compatibility
5 Instrumention tool PC (OS:Windows XP)
6 SD card (written the SD DIAG) more
than 16MB
(Format as FAT or FAT16)