EasyManua.ls Logo

Panasonic DMP-BD79 - Page 33

Panasonic DMP-BD79
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Reference
33
VQT4W89
The images from this unit do not appear on
the TV.
Picture is distorted.
¾ An incorrect resolution is selected in “HDMI
Video Format”. Reset the setting as follows:
1 Turn the unit on.
2 Press and hold [OK], the yellow button and
the blue button on the remote control at the
same time for more than 5 seconds.
Set the item again. (> 25)
When Dolby Digital Plus, Dolby TrueHD,
and DTS-HD audio are not output properly,
select “Yes” in “Default Settings” and make
proper settings. (> 29)
Video is not output in high-definition.
¾ Confirm that “HDMI Video Format” in the
Setup menu is set properly. (> 25)
A black band is displayed around the edge of
the screen.
The aspect ratio of the screen is abnormal.
¾ Confirm the “TV Aspect” is set properly.
(> 28)
¾ Adjust the aspect setting on the TV.
Cannot hear the desired audio type.
¾ Check the connections and the “Digital Audio
Output” settings. (> 9, 26)
Disc cannot be played.
¾ The disc is dirty. (> 5)
¾ The disc is not finalized. (> 7)
Still pictures (JPEG) do not play back
normally.
¾ The images that were edited on the PC, such
as Progressive JPEG, etc., may not be played
back.
I can’t play back BD-Live.
¾ Confirm that this unit is connected to the
broadband Internet. (> 10)
¾ Confirm the “BD-Live Internet Access”
settings. (> 28)
¾ Confirm a USB device is connected to the
USB port. (> 14)
Picture
INFO LED and POWER LED start to flash.
3 Press and hold [8] and the blue button on the
remote control at the same time for more than
5 seconds.
¾ The unit and TV are using different video
systems.
1 Turn the unit on.
2 Press and hold [OK], the yellow button and
the blue button on the remote control at the
same time for more than 5 seconds.
INFO LED and POWER LED start to flash,
and “00RET” is displayed on the screen.
3 Press [1] (right) repeatedly on the remote
control until “05P/N” is displayed on the
screen.
4 Press and hold [OK] for more than
5 seconds.
The system switches from PAL to NTSC or
vice versa.
¾ The system used on the disc doesn’t match
your TV.
PAL discs cannot be correctly viewed on an
NTSC TV.
Audio
Playback
DMP-BD79_EG-VQT4V15_mst.book 33 ページ 2013年1月17日 木曜日 午後2時36分

Other manuals for Panasonic DMP-BD79

Related product manuals