Getting started
SQT0351
21
1 Turn on the TV, then select the appropriate
AV input to suit the connections to this unit.
3 Select language, then press [OK].
4 Select country, then press [OK].
5 Select the channel number allocation, then
press [OK].
• Normally set to “Operator’s Channel
Number ( LCN )”.
6 Select “Start Auto Setup”, then press [OK].
9 Set Quick Start to “On”, “Off” or “Timer
Setting for Quick Start”, then press [OK].
10Select the item to match the type of TV
connected.
For details, refer to “TV Aspect”. (> 90)
When “Easy Setting has been completed.”
appears, Easy Setting is complete.
• Select “Yes” to proceed to “Easy Network
Setting”. (> 22)
• Select “No” to finish the Easy Setting.
You need to set “Preferred Language” after
completing “Easy Setting” or “Easy Network
Setting”.
1 Press [FUNCTION MENU]. (> 20)
2 Select “Basic Settings” in “Setup”, then press
[OK].
3 Select “Preferred Language” in “DVB Tuning”,
then press [OK].
4 Refer to page 85, “Preferred Language”.
Easy Setting
2 Press [Í] on the remote control or [Í/I] on
this unit.
• The Easy Setting will start at the initial
power on.
• Frequency
Auto
The preset frequency will be
automatically used.
Manual
Enter the frequency specified by your
cable provider with number buttons.
• Network ID
Auto
The preset Network ID will be
automatically used.
Manual
Enter the Network ID specified by your
cable provider with number buttons.
• Frequency and Network ID settings may be
necessary depending on the cable provider. For
details, consult the cable provider.
7 Auto Setup will start automatically.
(This operation may take some time.)
e.g.,
When tuning is completed, press [OK].
Auto Setup
Progress
This will take about 3 minutes.
No. Channel Name Type Quality
Free TV: 0 Pay TV: 0 Radio: 0
Searching
0%
100%
8 Clock will be set automatically.
If the clock setting screen appears, set the
time manually (> 94, Clock).
•On
It is possible to start quickly from standby
mode.
•Off
Power consumption in standby mode is
minimised. (> 110)
However, startup time from standby mode
will be longer.
• Timer Setting for Quick Start
“Quick Start” is activated when the set time
comes.
Preferred Language
DMR-BCT84_74EN_eng.book 21 ページ ２０１４年７月２４日 木曜日 午後５時３分
To Next Page
Loading...
