Panasonic DMR-BCT74 - Watching Broadcasts

Watching broadcasts
SQT0351
25
Watching broadcasts
Watchi ng
broadcasts
To switch to the channel you have previously
watched
Press [LAST VIEW ].
• This function will work only for the channels you
have watched for more than 10 seconds.
To switch to the radio channels or to the all
channels
Press [RADIO/TV].
• Selection of channel is made easy by creating a Favourite
of the channels. (> 84, Favourites Edit)
• When you are watching the 3D programme, subtitles and
TV Guide, etc., may not be displayed correctly depending
on the settings. (> 48, 49, 3D Type, Signal Format)
Enter the PIN with the number buttons by
following the on-screen instructions.
• If you decide on a PIN, make a note it in case
you forgot it.
• PIN (except CAM’s) can be changed via “PIN
Entry”. (> 94)
• For CAM’s PIN, refer to your CAM’s operating
instructions.
To watch an encrypted broadcast, insert the CI
module into the CI slot. (> 14)
• Set according to the CI module. (> 82, 91,
Common Interface)
Instructions for operations are generally
described using the remote control. (> 12)
1 Press [INPUT SELECT] and select “TV”,
then press [OK].
• If the Operator profile is being updated, a
different display may appear on the
screen. (> 28)
2 Press [CH WX] to select the channel.
• You can also select the channel by the
following operations.
- Using number buttons
- Using Channel List (> 26)
- Using TV Guide system (> 26)
- Using channel information (> 27)
If this unit requests a PIN
If encrypted channels do not appear
DMR-BCT84_74EN_eng.book 25 ページ ２０１４年７月２４日 木曜日 午後５時３分