Panasonic DMR-BCT835 - Easy Network Setting

Getting started
Settings
Easy Network Setting
After completing “Easy Setting”, you can
continue with “Easy Network Setting”.
1 Select “Wired” or “Wireless”, then press
[OK].
Easy Network Setting
Settings and tests for
connection required for home
network and the Internet will
be conducted.
First, please select a connection mode.
Current setting : Wired
LAN cable connection:
Connect a LAN cable to the unit and select 'Wired'.
Wireless LAN connection:
Select 'Wireless'.
Wired
Wireless
U_________________________
2 Follow the on-screen instructions and
make the following confirmation and
settings. “Wired” connection:
- Home Network Connection Check
- Home Network function
- Remote Recording function
- Internet Connection Test
“Wireless” connection:
• Before beginning wireless connection
setup obtain your Network name (SSID).
An SSID (Service Set IDentification) is a
name used by wireless LAN to identify a
particular network. Transmission is
possible if the SSID matches for both
devices.
- Wireless Settings
- Home Network Connection Check
- Home Network function
- Remote Recording function
- Internet Connection Test
3 When “Easy Network Setting is finished.”
appears.
Press [OK].
Connection method to wireless access point
Search for wireless network:
1 Select “Search for wireless network”, then
press [OK].
2 The available wireless networks will be
displayed. Select your network name and
press [OK].
- If your Network name is not displayed
search again by pressing the red button
on the remote control.
- Stealth SSID will not be displayed. Enter
manually by using “Wireless Settings”.
(O 84, 96)
• If your wireless network is encrypted,
Encryption Key Input Screen will be
displayed.
Input the encryption key of your network.
WPS (PUSH button):
If your Wireless router supports WPS (PUSH
button), you can easily perform the settings by
pressing WPS button on it.
WPS (Wi-Fi Protected Setup™) is a standard
that facilitates settings relating to the
connection and security of wireless LAN
devices.
1 Select “WPS (PUSH button)”, then press
[OK].
2 Press WPS button or corresponding button
of Wireless router until the lamp starts
flashing.
• Wi-Fi Protected Setup™-compatible
Wireless router may have the mark.
• For details, refer to the operating
instruction of Wireless router.
3 Press [OK].
24
VQT4W71