Troubleshooting
SQT0292
117
If there is any problem, the following message is
displayed on the screen.
When you experience problems with
Easy Network Setting
Wireless Settings
Display Check the following
A conflict with
other devices
occurred.
• Please wait a few moments,
and then try again.
A time out error
occurred.
• Setting of the Wireless router
for MAC Address etc.
• The signal may be weak.
• The SSID and the encryption
key of the Wireless router.
• Please wait a few moments,
and then try again.
An
authentication
error or a time
out error
occurred.
A device error
occurred.
• If the problem is not solved,
consult your dealer.
Easy Network Setting ( Home Network
Connection Check )
Display
Check the
following
1. LAN cable
connection or
Wireless setting:
“Fail”
• Connection
of the LAN
cables
(> 21)
• Settings of
the hub and
router
2. IP address
setting:
“Fail”
3. Connection to
gateway:
“Fail”
Display
Check the
following
1. LAN cable
connection or
Wireless setting:
“Pass”
• Connection
and settings
of the hub
and router
• Settings of
“IP Address /
DNS
Settings”
(> 87, 100)
2. IP address
setting:
“Fail”
3. Connection to
gateway:
“Fail”
1. LAN cable
connection or
Wireless setting:
“Pass”
2. IP address
setting:
“Pass”
3. Connection to
gateway:
“Fail”
1. LAN cable
connection or
Wireless setting:
“Pass”
2. IP address
setting:
“Home
network
available”
3. Connection to
gateway:
“Fail”
Easy Network Setting ( Internet Connection
Test )
Display Check the following
Cannot find the
server. (B019)
• “Primary DNS” and
“Secondary DNS” settings
of “IP Address / DNS
Settings” (> 87, 100)
No connection
could be made to
the server. (B020)
• The server may be busy or
the service may have been
suspended. Please wait a
few moments, and then try
again.
• Settings of “Proxy Server
Settings” (> 87, 100) and
the router.
DMR-BST_BCT940EG_eng.book 117 ページ ２０１４年７月２日 水曜日 午後５時４０分
To Next Page
Loading...
