Getting started
SQT0292
13
• While writing to/reading from the media, do not switch the
unit to standby mode or remove the media. Such action
may result in loss of the media contents.
• When inserting the media, ensure that it is facing the right
way up.
Main unit
1 Remote control signal sensor
• Angle: Approx. 20° up and down, 30° left and
right
• Distance: Within approx. 7 m in front of the
unit
2 Open/close disc tray
3 Standby/on switch (Í/I)
Press to switch the unit from on to standby
mode or vice versa. In standby mode, the unit
is still consuming a small amount of power.
4 CI module eject button (> 14)
5 CI (Common Interface) slot (> 14)
6 Recording indicator
• The indicator will light up while recording.
• The indicator will blink while recording is
paused and before recording starts.
7 Disc tray
8 USB port
9 SD card slot
• When removing the SD card, press on the
centre of the card and pull it straight out.
Display
Pull to flip down the
front panel.
Display
1 Main display section indicator
- Current time
- Name of a broadcasting station
- Playback counter
- Various messages (> 115), etc.
2 Drive (HDD, BD or SD) indicator
3 Playback indicator
4 SD card slot indicator
5 USB port indicator
6 Disc indicator
7 Copying indicator
8 Remote control signal indicator
9 Timer recording indicator
This indicator lights up when the timer
recording standby or Keyword Recording
standby is activated.
DMR-BST_BCT940EG_eng.book 13 ページ ２０１４年７月２日 水曜日 午後５時４０分
To Next Page
Loading...
