Convenient functions
SQT0826
82
Software (Firmware) Update
Software of this unit can be updated automatically
by the following methods at the specified time.
(Default setting is 3 a.m. > 80, Software Update
in Standby)
• To update the software (Firmware) immediately,
use the following function:
- Software Update Now ( Internet )
§
:
Software of this unit will be updated from
Internet if update information is detected.
§
Network connection and setting are required.
(> 18, 21)
If a software (firmware) update is available, a
notification is displayed.
• It is displayed on the channel information (> 24)
when the Software (Firmware) can be updated
immediately.
To execute, press the red button while the
channel information is displayed, and follow the
instructions on the screen.
Update of the software (firmware) will start when
the unit is turned to standby mode.
e.g.,
• When “FINISH” is displayed, update of the
software (firmware) has completed.
You cannot operate the unit until the update
is complete. Don’t remove the AC mains lead
during the update. Removing the AC mains
lead while the update is in progress may
damage the unit.
- From Internet
§
The front panel display during the update
• It may take up to a few hours until the update is completed
depending on the network environment.
• The timer recording always takes preference over the
software (Firmware) download; if the timer recording is
scheduled to start, the downloading will be performed at the
next opportunity.
• You can also download the latest software (firmware) from
the following website.
http://panasonic.jp/support/global/cs/
New software version has been found.
The software will be updated automatically
after this unit is switched to standby.
Do not disconnect the AC mains lead.
10:30 AM
1
Now
Dolby DRating: G
Change category
All Digital Channels
NEWS
9:00 AM - 11:00 AM
Software update
DMR-BWT450GL_eng.book 82 ページ ２０１５年２月５日 木曜日 午後３時２８分
To Next Page
Loading...
