40
U88 The unit is carrying out its
recovery process.
No display
U99 Hang-up Displayed when communication error has
occurred between Main microprocessor and
Timer microprocessor.
No display
Displayed is left until the [POWER]
key is pressed.
H19 02 Inoperative fan motor When inoperative fan motor is detected after
powered on, the power is turned off automati-
cally. The event is saved in memory.
No display No display
F00 No error information Initial setting for error code in memory (Error
code Initialization is possible with error code
initialization and main unit initialization.)
No display
F34 Initialization error when main
microprocessor is started up
for program recording
When initialization error is detected after start-
ing up main microprocessor for program
recording, the power is turned off automati-
cally. The event is saved in memory.
No display No display
F58 Drive hardware error When Drive unit error is detected, the event
is saved in memory.
No display No display
F74 HDMI Device Key Communi-
cation error
HDMI connection could not be authenticated
due to a transfer malfunction.
Factor of HDMI Device key-road failure
• When HDMI LSI is damaged.
• When the bus line of I2C doesn't operate
normally.
• When device key information recorded is
damaged.
No display
F75 HDMI Device Key Information
error
HDMI connection could not be authenticated
due to an internal data malfunction.
Factor of HDMI Device key-road failure
• When HDMI LSI is damaged.
• When the bus line of I2C doesn't operate
normally.
• When device key information recorded is
damaged.
No display
BD * Remote control code error Display appears when main unit and
remote controller codes are not matched.
No display
"*" is remote controller code of the
main unit.
Display for 5 seconds.
UNSUPPO-
RT
Unsupported disc error *An unsupported format disc was played,
although the drive starts normally.
*The data format is not supported, although
the media type is supported.
*Exceptionally in case of the disc is dirty.
“This disc is
incompatible.”
Displayed for 5 seconds.
The character indication flows
sideways.
NO READ Disc read error *A disc is flawed or dirty.
*A poor quality failed to start.
*The track information could not be read.
“Cannot read.
Please check the
disc.”
HARD
ERR
Drive error The Drive detected a hard error. “BD Drive error.” Display for 5 seconds.
The character indication flows
sideways.
SELF
CHECK
Restoration operation Since the power cord fell out during a power
failure or operation, it is under restoration
operation.
*It will OK, if a display disappears
automatically. If a display does not
disappear,there is the possibility that
defective Digital P.C.B. / BD Drive.
No display
The character indication flows
sideways.
Error Code Diagnosis Contents Description Monitor Display Automatic FL display
To Next Page
Loading...
