Panasonic DMR-HST270 - Copying Content: Programmes and Video Files; Programme Copying Process; Setting Copying Options

Copying video
TQBS0165
38
Copying programmes
The unit can copy programmes between the HDD
and USB-HDDs.
To register the external HDD (USB HDD)
(> 26)
To copy video files (> 39)
1 Select “No”, then press [OK] in step 6 (> left).
2 Select the programme, then press the yellow
button.
Repeat this step to select programmes.
3 Press the blue button.
4 Go to step 6 (> left).
About screen icons on the Video Menu
Refer to “Screen icons”. (> 27)
§
§
“For recorded programmes (> 66)” only
• The programme in the source media will be
deleted.
1 Connect the USB HDD.
2 Press [FUNCTION MENU].
3 Select “Recorded Programmes” in
“Contents on HDD”, then press [OK].
4 Select the programme.
• Multiple selection
Select the programme, then press the
yellow button.
A check mark
is displayed. Repeat this
step.
• Press the yellow button again to cancel.
5 Press the blue button.
6 Select “Yes”, then press [OK].
• If you select “No”, you can change the
selection. (> right, To change the
selection)
7 Set other settings, then press [OK].
(> right, “Setting the copying options”)
8 Select “Yes”, then press [OK].
Copying video
To change the selection
Setting the copying options
1 Select the item in step 7 (> left).
2 Press [2, 1] to change the settings.
• Automatic Standby after Copy
On:
This unit is turned to standby mode when it is
not operated for approximately 5 minutes
after completing copy.
DMR-HST270GZ_eng.book 38 ページ ２０１７年１２月２６日 火曜日 午後５時４７分