Getting started
TQBS0165
6
Main unit
• When inserting the media, ensure that it is facing the right
way up.
• While writing to/reading from the media, do not switch the
unit to standby mode or remove the media. Such action
may result in loss of the media contents.
• The USB port on the front side does not support
USB HDDs. Connect a USB HDD to the USB port on the
rear side. (> 26, Connecting the USB HDD)
Front
Pull to flip down
the front panel.
1 Display (> 7)
2 Remote control signal sensor
• Angle: Approx. 20° up and down, 30° left and
right
• Distance: Within approx. 7 m in front of the
unit
3 Play
4 Standby/on switch (Í/I)
Press to switch the unit from on to standby
mode or vice versa. In standby mode, the unit
is still consuming a small amount of power.
5 USB port ( DC 5 V 500 mA)
Inserting or removing media
∫ USB device
DMR-HST270GZ_eng.book 6 ページ ２０１７年１２月２６日 火曜日 午後５時４７分
To Next Page
Loading...
