Getting started
VQT3F57
14
Settings
7 Set “Power Save” to “On”, “On Timer”
or “Off”, then press [OK].
When the following screen appears, Easy Setting
is complete.
≥Select “Yes” to proceed to “Network Easy Setting”.
(> 15)
≥Select “No” to finish the Easy Setting.
To stop partway
Press [BACK/RETURN ].
To restart set up
1 Press [DRIVE SELECT] to select the HDD drive.
2 Press [FUNCTION MENU].
3 Select “Setup”, then press [OK].
4 Select “Auto Setup” in “Tuning”, then press [OK].
5 Select “Yes”, then press [OK].
To display the Owner ID information on TV
1 While the unit is on, press and hold [OK], the
“Yellow” button and the “Blue” button on the
remote control at the same time for more than
5 seconds.
–“00 RET” is displayed on the unit’s display.
2 Repeatedly press [1] (right) on the remote control
until “01 OID” is displayed on the unit’s display.
3 Press [OK] on the remote control.
The PIN is not displayed.
¾ To edit the Channel List (> 71, Channel List)
¾ To check the signal condition (> 72, Signal
Condition)
¾ To change PIN for parental control (> 79, PIN
Entry)
¾ To sort the Channel List by region (> 71,
Channel Sorting by Region)
On It will go into the Power Save in
Standby mode.
On
Timer
Set the start and stop time and then
press [OK].
≥Power Save in Standby mode is
activated at the set time period.
Off It is possible to start quickly from the
standby mode. (Quick Start mode)
≥If you use Home Network ( DLNA )
Server function (> 77), select “Off”.
This function is not available with
other settings.
Power Save in Standby
From To
Power Save
0 6
On
OK
Easy Setting
Easy Setting has been completed.
To use Internet functions, network connection needs
to be made first. Proceed Network Easy Setting ?
Select “Yes” to start. Select “No” to exit the Setup.
Yes No
DMR-HW100EB-VQT3F57_eng.book 14 ページ ２０１１年８月５日 金曜日 午後２時４分
To Next Page
Loading...
