Panasonic DMR-HW100EBK - Others

Convenient functions
VQT3F57
78
Changing the unit’s settings (Setup)
∫ Standby Settings
¾ Power Save in Standby
≥This function cannot be enabled when the
DLNA function is enabled in “Home Network
( DLNA ) Server function”. (> 77)
≥The setting may be changed to “Off”
automatically when the setting for video
communication is changed. (> 61)
¾ Automatic Standby
Set the time to turn the unit to standby mode
automatically.
After the unit has finished operating, the unit will
be turned to standby mode once the set time has
passed.
≥When “REWIND LIVE TV” is set to “On” (> 73),
“Off” cannot be selected.
¾ Automatic Standby after OTR
If “On” is selected, this unit is turned to standby
mode when it is not operated for approximately
5 minutes after completing “Automatic Stop” or
“Recording Time” (> 27).
¾ Automatic Standby after Copy
If “On” is selected, this unit is turned to standby
mode when it is not operated for approximately
5 minutes after completing copy. (> 59, 60)
¾ RF OUT ( Aerial Signal )
Set whether to output the aerial signal or not from
RF OUT while in standby mode (when “Power
Save in Standby” is activated).
≥If “On” is selected, the aerial signal is output
from this unit.
∫ Remote Control
Change the remote control code on the main unit and
the remote control if you place other Panasonic
products close together.
≥Use “Set Code 1”, the factory set code, under
normal circumstances.
1 Select the code, then press [OK].
2 While pressing [OK], press and hold the number
button ([1] to [6]) for more than 5 seconds.
3 Press and hold [OK] for more than 5 seconds.
4 Press [OK].
≥Operation is possible only with Panasonic remote
controls with “IR6” printed at the bottom when the
remote control code of this unit is set to “Set
Code 4”, “Set Code 5” or “Set Code 6”.
Others
On It will go into the “Power Save in
Standby” mode.
On
Timer
“Power Save in Standby” is activated
when the set time comes.
≥If the clock has not been set, “Power
Save in Standby” is activated at all
hours.
Off It is possible to start quickly from the
standby mode. (Quick Start mode)
Setup
Others
Others
Standby Settings Enlgish
Remote Control
Clock
PIN Entry
System Update
System Information
DivX Registration
Initialize
Owner ID
Others
Standby Settings Enlgish
Standby Settings
Power Save in Standby
Enlgish
Automatic Standby
Automatic Standby after OTR
Automatic Standby after Copy
RF OUT ( Aerial Signal )
HDD RECORDER
IR6
HDD RECORDER
IR6
IR6
DMR-HW100EB-VQT3F57_eng.book 78 ページ ２０１１年８月５日 金曜日 午後２時４分