Convenient functions
VQT3F57
79
∫ Clock
If the time is not set correctly, use the settings listed in
the method below.
≥Automatic
This unit usually obtains time and date information
from digital broadcasts.
But, if the time is not set correctly, set it to “Off” and
perform “Manual Setting”.
≥Time Zone
When the time is not correct, set “Time Zone”.
(GMT - 6 to + 6)
≥Manual Setting
1 Select “Off” of “Automatic”, then press [OK].
2 Select the item you want to change.
3 Change the setting.
4 Press [OK] when you have finished the settings.
∫ Owner ID
In order to prevent another person from using this unit
if it is stolen, you can set a PIN and input your personal
information (NAME, HOUSE NO, POSTCODE).
Once the PIN has been set, you cannot return to
the factory preset. Make sure not to forget this.
∫ PIN Entry
You can set/change the PIN for parental control.
(> 70)
∫ System Update
¾ Software Update in Standby
When you set this unit to standby mode, software
(firmware) updates (> 81) are downloaded
automatically.
¾ Software Update Now ( Broadcast )
Software of this unit will be updated from
broadcasts if update information is detected.
(> 81)
¾ Software Update Now ( Internet )
Software of this unit will be updated from Internet
if update information is detected. (> 81)
¾ Software Licence
Information about the software licence is
displayed.
¾ Post Code
Input the postal code which is necessary to
download area specific information of GUIDE
Plus+ system.
¾ Guide Plus+ System Information
You can check the condition of GUIDE Plus+
system of this unit.
Clock
Time Date
Time Zone
Automatic
Please set the clock.
OK : access RETURN : leave
OK
RETURN
0
00
10
Automatic
On
11
2011
Others
System Update
System Update
Software Update in Standby Enlgish
Software Update Now ( Broadcast )
Software Update Now ( Internet )
Software Licence
Post Code
GUIDE Plus+ System Information
DMR-HW100EB-VQT3F57_eng.book 79 ページ ２０１１年８月５日 金曜日 午後２時４分
To Next Page
Loading...
