Panasonic DMR-PWT550 - Easy Network Setting

Getting started
SQT0815
22
Settings
Easy Network Setting
1 Select “Wired” or “Wireless”, then press
[OK].
2 Follow the on-screen instructions and make
the following confirmation and settings.
“Wired” connection:
- Network Connection Check
- Home Network function
- TV Anytime
“Wireless” connection:
• Before beginning wireless connection
setup obtain your Network name (SSID).
An SSID (Service Set IDentification) is a
name used by wireless LAN to identify a
particular network. Transmission is
possible if the SSID matches for both
devices.
- Wireless Connection Check
- Network Connection Check
- Home Network function
- TV Anytime
3 When “Easy Network Setting is finished.”
appears
Press [OK].
Search for wireless network:
1 Select “Search for wireless network”, then
press [OK].
2 The available wireless networks will be
displayed. Select your network name and
press [OK].
- If your Network name is not displayed,
search again by pressing the red button on
the remote control.
- Stealth SSID will not be displayed. Enter
manually by using “Wireless Settings”.
(> 71, 79)
• If your wireless network is encrypted,
Encryption Key Input Screen will be
displayed.
Input the encryption key of your network.
3 Select “Set”, then press [OK].
WPS (PUSH button):
If your Wireless router supports WPS (PUSH
button), you can easily perform the settings by
pressing WPS button on it.
WPS (Wi-Fi Protected Setup™) is a standard that
facilitates settings relating to the connection and
security of wireless LAN devices.
1 Select “WPS (PUSH button)”, then press [OK].
2 Press WPS button or corresponding button of
Wireless router until the lamp starts flashing.
• Wi-Fi Protected Setup™-compatible
Wireless router may have the mark.
• For details, refer to the operating instructions
of Wireless router.
3 Press [OK].
Easy Network Setting
OK
RETURN
Easy Network Setting
Settings and tests for connection required
for home network and the Internet will be
conducted.
First, please select a connection mode.
LAN cable connection:
Connect a LAN cable to the unit and select “Wired”.
Wireless LAN connection:
Select “Wireless”.
Current setting : Wired
Wired
Wireless
Connection method to wireless access point
e.g.,
DMR-PWT550GLGZ_eng.book 22 ページ ２０１５年２月２日 月曜日 午後７時２６分