Panasonic DP-180 - Network Scanner; Document Scanning; Selecting the Scanning Resolution

46
UF-9000
JUN 2004
Ver. 2.0
DP-180/190
3.1.2. Jam Error Codes (J Code)
Section Jam Location
AADF
B Paper Transport / Exit Area
C Paper Entry Area
Jam Error Codes (J Codes) Table
Code Contents Section
J00 The Registration Sensor did not detect paper within a predetermined time after paper
started feeding. (Sheet Bypass)
C
J01 The Registration Sensor did not detect paper within a predetermined time after the
Paper Feed Roller started rotating. (1st Feeder Unit)
C
J02 The Registration Sensor does not detect paper within a predetermined time after the
Paper Feed Roller started rotating. (2nd Feeder Unit)
C
J43 The Exit Sensor does not detect paper within a predetermined time after the Fuser
Unit Paper Exit Sensor is activated.
B, C
J44 The Exit Sensor keeps detecting paper after a predetermined time. B, C
J70 Read Point Sensor does not go ON within 10 seconds after the original starts feeding.
(Information Code 030 is printed on the Transaction Journal instead.)
A
J71 Original was longer than 78.7 in (2m).
(Information Code 031 or 032 is printed on the Transaction Journal instead.)
A
J79 The ADF Read Point Sensor keeps detecting paper in the ADF. A
J80 The Automatic Duplex Unit (ADU) Entrance Sensor does not detect paper within a
predetermined time.
C
J82 The ADU Exit Sensor does not detect paper within a predetermined time after ADU
Middle Sensor is activated.
C
J83 The ADU Entrance Sensor keeps detecting paper after a predetermined time has
lapsed.
C
J90 The PRINT signal is not received within 1 minute after the FEED signal is received. -
J91 The Paper Tray was pulled out when feeding a paper. C
J92 The Front Cover was opened when feeding a paper. C
J93 The paper remained in the ADF. A
A
B
C