783
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
Fig. 3-043
2-7. Removing the Staple/Fold Drive Unit
(1) Open the Front Door [1], and slide out the
Stapler Unit [2] slightly to the front.
Fig. 3-044
(2) Remove 1 screw [3], and detach the Interface
Retainer [4].
(3) Free the six Harness Retainers [5], and
disconnect the Connector [6].
(4) Free the Harness [7] from the Harness Retainer
[5].
(5) Free the Harness [7] from the Edge Saddle [8];
then, disconnect the two Connectors [9].
Fig. 3-045
(6) Release the Harness Retainer [10], and
disconnect the Connector [11].
(7) Free the Harness [12] from the Harness Retainer
[10].
(8) Free the Harness [12] for the Edge Saddle [13];
and disconnect the two Connectors [14].
[1]
[2]
[9]
[8]
[7]
[5]
[5]
[5]
[7]
[7]
[7]
[4]
[3]
[5]
[6]
[11]
[12]
[10]
[13]
[14]
To Next Page
Loading...
