Panasonic DP-8032 - Page 189

189
DP-8032/8025
2008Ver. 1.2
5.1.5. F6 Mode: Adjust Parameters (For Copier)
Set the machine to Service Mode and press “6” key on the Keypad.
↓
Press the “START” key.
↓
Select the desired code number on the Touch Panel display.
↓
If you wish to select another code number, scroll the menu with the arrow buttons.
↓
Select the desired function on the Touch Panel display and touch the “OK” button.
↓
When the “C (CLEAR)” key is touched, the selected code input will not be accepted.
↓
Press “FUNCTION” and “C (CLEAR)” keys simultaneously to exit the service mode.
↓
Reboot the machine after setting the parameter(s) to activate the setting(s).
F6 Mode
No. Item Remarks
Setting
Range
00 Adj 100% Side-Side Read Adjustment of ratio for vertical position when scan
is made.
-9 ~ +9
0.1 %
01 Adj 100% Lead-Tail Read Adjustment of ratio for parallel position when scan
is made.
-9 ~ +9
0.1 %
02 100% Selection Adjustment from 99.1% to 100.9% -9 ~ +9
0.1 %
03 Original Registration Adjustment of platen original registration detection
timing.
-30 ~ +30
0.2 mm
04 Printer Registration Delay time is adjusted from registration roller clutch
ON.
-50 ~ +50
0.5 mm
05 Main Motor Speed Adjustment of Main Motor speed. -10 ~ +10
0.1 %
06 Polygon Motor Speed Adjustment Polygon Motor speed. -5 ~ +5
0.1 %
07 Registration Void Registration void should be adjusted. 0 ~ +99
0.5 mm
08 Trail Edge Read Timing Adjustment of trail edge void. -9 ~ 0
0.5 mm
09 Trail Edge Print Timing Adjustment of trail edge void. -9 ~ +15
0.5 mm
10 Side Adjust (Bypass) Adjustment of LSU side-side (Sheet Bypass). -8 ~ +7
0.5 mm
11 Side Adjust (Tray 1) Adjustment of LSU side-side (1st Tray). -8 ~ +7
0.5 mm
12 Side Adjust (Tray 2) Adjustment of LSU side-side (2nd Tray). -8 ~ +7
0.5 mm
13 Side Adjust (Tray 3) Adjustment of LSU side-side (3rd Tray). -8 ~ +7
0.5mm
14 Side Adjust (Tray 4) Adjustment of LSU side-side (4th Tray) -8 ~ +7
0.5 mm
15 Not Used
16 Side Adjust (ADU) Adjustment of LSU side-side (ADU). -8 ~ +7
0.5 mm