Panasonic DP-C305 - Page 544

544
DP-C405/C305/C265
FEB 2008Ver. 1.1
640 Patch Sens Read Y To detect the toner density of the patch on the
transfer belt at APIC and reflect to patch
compensation (F6-610 - F6-613) after data
process.
0 ~ +255
(Read only)
641 Patch Sens Read M 0 ~ +255
(Read only)
642 Patch Sens Read C 0 ~ +255
(Read only)
643 Patch Sens Read BK 0 ~ +255
(Read only)
644 Not Used
645 Reg Sens Dirty Std Read Image density sensor dirt base value.
When executing Shipment set or F8-29, the
Image density sensor calibration data is stored.
This value is the base of F6-646
-127 ~ +127
(Read Only)
646 Reg Sens Dirty Mon Read Image density sensor dirt monitor.
When executing Shipment set or F8-29, value is
reset to "0".
If Sensor surface is dirty, "-"value will be stored.
If lower than "-10", the Image density sensor
should be clean.
-127 ~ +127
(Read Only)
647-
649
Not Used
650 APIC DC Charge Read Y
(DP-C322 Series Only)
(Factory use only)
-27 ~ +27
(Read Only)
651 APIC DC Charge Read M
(DP-C322 Series Only)
-27 ~ +27
(Read Only)
652 APIC DC Charge Read C
(DP-C322 Series Only)
-27 ~ +27
(Read Only)
653 APIC DC Charge Read BK
(DP-C322 Series Only)
-27 ~ +27
(Read Only)
654 Not Used
655 APIC DC Bias Read Y
(DP-C322 Series Only)
(Factory use only)
-32 ~ +32
(Read Only)
656 APIC DC Bias Read M
(DP-C322 Series Only)
-32 ~ +32
(Read Only)
657 APIC DC Bias Read C
(DP-C322 Series Only)
-32 ~ +32
(Read Only)
658 APIC DC Bias Read BK
(DP-C322 Series Only)
-32 ~ +32
(Read Only)
659 Not Used
660 APIC Laser Read Y
(DP-C322 Series Only)
(Factory use only)
-127 ~ +127
(Read Only)
661 APIC Laser Read M
(DP-C322 Series Only)
-127 ~ +127
(Read Only)
662 APIC Laser Read C
(DP-C322 Series Only)
-127 ~ +127
(Read Only)
663 APIC Laser Read BK
(DP-C322 Series Only)
-127 ~ +127
(Read Only)
664 Not Used
F6 Mode
No. Item Remarks Setting Range