This page explains how to connect the unit to a television and set it up so you hear the audio through the television’s speakers. To get the full benefit from
the powerful multi-channel audio found on DVDs, YOU should connect an amplifier and speakers (=+ page ‘?a).
@Refer to the television’s operating instructions.
- AC power
(included)
The illustration shows
DVD-CPB7.
,---...
-- ...” .
“-‘.-..X --
8V OUT ~~~~~~~~
The o terminal achieves a more vivid picture than the VIDEC
OUT temiinal by separating the chrominance (C)
and
luminance (Y
signals. (Actual results depend on the television.)
‘~‘elevi~~~~~
video cable
ot included)
-...A. ,.‘~--^ ,,, I
When making this connection, ensure you connect the audio cables
to the corresponding audio input terminals on the television.
..-.- - .._ .- -/
-\
s the calor difference
signals (PB/PR) and luminance signal (Y) separately in order to
achieve high fidelity in reproducing colors.
@The description of the component video input lerminals depends
on the television or monitor (e.g. YIPBIPR, Y/B-Y/R-Y, Y/CS/CR).
Connect to terminals of the same color.
@After making this connection, change the black Ievel for a better
picture (9 page 16, Video--Black Level Control).
cavil
These terminals can be used for either interlace or progressive
output and provide a purer picture that) the S VIDEO OUT
When rnaking this connection, ensure you connect the audio cables
to the corresponding audio input terminals on the television.
A.” ..- ~-_.--..
.-- _______.-._ --1
This unil consumes a small amount of power, even when it is turned off (approx. 2.5 W). To save power when the unit is not to be used for a long time,
unplug it from the household AC outlet.
elnsert so the poles (+ and -) match those in the remote control.
@Do not use rechargeable type batteries.
@use different types at the same tirme.
@heat or expose to flame.
@ake apart or short circuit.
oattempt to recharge alkaline or manganese batteries.
@use batteries if the covering has been peeled off.
Mishandling uf batteries can cause electrolyte leakage which can damage
items the fluid contacts and rney cause a fire.
Remove if the remote control is not going to be used inr a long period of
time. Store in a cool, dark place.
Aim at the sensor. avoiding obstacles, at a maximum range of 7 m (23 feet)
directly in front of the unit.
The QUI
S~~~~
To Next Page
Loading...
