Panasonic DVD-LA95 - Built-in Battery Operation; Charging the Built-in Battery; Battery Charge Confirmation and Playtime; Battery Detachment and Reattachment

∫ To confirm the battery charge on the
LCD
Press [DISPLAY].
The battery display appears on the LCD for
a few seconds.
It roughly shows the remaining charge.
(This appears automatically when there is
about 10 minutes of charge remaining.)
∫ If play time dramatically reduces after
recharging
The battery has reached the end of its
service life (it can be recharged about
300 times).
∫ If the unit is not to be used for a long
time
≥Detach the battery. (Even if the unit is off,
it still uses some power. This can lead to
over discharging of the battery and
malfunction.)
≥Recharge the battery when you are ready
to use it again.
∫ To detach the built-in battery
∫ (When the unit is off)
1 Slide and lift the latch.
2 Lift the battery out of the unit.
Getting Started
13
RQT6050
≥Charge the battery before using it for the
first time.
≥Quote the following part number when
replacing the battery pack.
≥CGR-H602
≥(available from Panasonic dealers)
∫ To recharge the built-in battery
∫ (When the unit is off)
Connect to the household mains socket
while the battery is attached (see left).
CHG
Recharging
[at 20 oC]
3 hours
3 hours
3 hours
LCD
brightness
level
j5
0
5
LCD on
2 hours
30 minutes
2 hours
1 hour
30 minutes
LCD off
3 hours
30 minutes
3 hours
30 minutes
3 hours
30 minutes
Play time
Full Low Recharge
Using the built-in battery (Lithium ion battery pack)
Note
Refer to “Precautions” on page 8.
∫ Approximate recharging and play
times
(Actual times depend on operating
conditions)
Recharging
Front of this unit
The [CHG] indicator lights.
The [Í] indicator goes out.
1
2
Built-in
battery
Bottom of
the unit
Bottom of
the unit
Note
After detaching the built-in battery, take care
when handling the unit.
∫ To attach the built-in battery
∫ (When the unit is off)
1 Insert the battery’s flange into the slot in
the compartment.
2 Push the battery so it clicks into place.
Lock release button
≥Brightness is factory preset to “0”.
≥To change the LCD brightness
(➡ page 21).
1
2
Built-in battery
Recharging is complete when [CHG]
goes out. (The [Í] indicator lights.)
Disconnect the AC mains lead and AC
adaptor.
f
}
For longer use
Power the unit together with the optional
battery pack (➡ page 37).