Appendix
In these cases? Check here.
The ECONAVI lamp does not light properly.
(Model : NR-CY55C (GKAU))
ECONAVI does
not operate.
(the ECONAVI
lamp does not
light)
●Has the “Quick Freezing” mode been activated? (P.14)
●Is the temperature setting of the freezer compartment set to
something other than “Med”?
●Has the door been opened frequently or has hot food been
placed in the refrigerator?
●The learning function may automatically disable ECONAVI
operation during times of frequent use.
ECONAVI
operation is rarely
performed.
●Is there a power failure?
If a power failure occurs, the learning function data collected
up until the point of power failure will be lost.
The ECONAVI operation will rarely be performed until the
learning function has collected data again.
ECONAVI
operation is
stopped part
way though.
●If the auto defrost function is turned on during ECONAVI
operation, the normal cooling operation will need to be
performed after defrost.
Therefore the ECONAVI operation may be stopped during this
defrost/cooling process.
●The learning function may sometimes restart the normal
cooling operation.
ECONAVI
operation is
performed too
often (the
ECONAVI lamp
rarely turns off).
●Is the light intensity sensor hidden?
●Are there dirt or scratches on the control panel where the light
intensity sensor is located?
●ECONAVI operation may be performed while the refrigerator is
being used depending on the conditions of use, but the cooling
performance is maintained.
23
ARAH1E200680_EN.indd 23 8/14/19 10:03 AM
To Next Page
Loading...
