88
Control of 2WAY SYSTEM
2. Wireless Remote Controller
Use [Emergency Operation] in the following situations when there is an urgent need.
When the remote controller’s batteries have failed.
When the remote controller is broken.
When the remote controller is lost.
CZ-RWSU3 / CZ-RWSC3
Start : press [Emergency Operation] of the receiver.
If the indoor temperature is 24 °C or greater when the unit starts running, it will act as a cooler.
If the indoor temperature is less than 24 °C when the unit starts running, it will act as a heater.
Stop : press [Emergency Operation]
of the receiver again.
8-29. Emergency Operation
CZ-RWSU3
Start/Stop
CZ-RWSC3
Start/Stop
8-30. Miscellaneous Settings
A variety of changes can be made to settings, depending on the indoor unit being used.
Operation mode indicator, time display (24 hour, AM/PM), Heat Max Temp
• (These settings are saved in nonvolatile memory in the remote controller, so even when its batteries are changed,
the settings do not have to be made again.)
• First check the display of the remote controller when the unit is stopped and then make any desired settings.
How to Operate
• While holding down the buttons below, every time is pressed the remote controller’s display changes.
• Whatever is being displayed when you release
is set.
Setting Item Operation Button Setting Content Remote Controller Display
Remote controller
operation mode
display setting
when is pressed
Press
while pressing
Heat Pump
(with Auto)
Heat Pump
(without Auto)
Dedicated air
conditioner
Clock display
setting
Press
while pressing
24 Hour
AM/PM
Max possible
temperature
setting in the
Heat mode
Press
while pressing
Maximum heating
temperature range is
26 °C – 30 °C
8-25
SM830276-00_欧州向け R32シングル TD＆SM.indb 25 19/02/18 11:16:08
To Next Page
Loading...
