88
2. Settings
SM830256-00_Single_欧州小筺体 TD&SM.indb 16 16/12/28 13:40:31
Setting for Receiver
ScrewPCB cover
Receiver PCB
Main/Sub selector
switch for remote
controllers (4)*
OFF: Main
ON: Sub
Set its address
(1) to (3)
All set at OFF
when shipped
from the factory.
ON
1 2 3 4
Check the settings of the [S003] DIP switch on the
receiver’s PCB.
* Remove the cover from the receiver when
* When using the infrared remote controller and
the wired remote controller in combination,
set the wired remote controller to [Main].
performing the PCB settings.
Setting Address Switches
When more than 1 receiver is installed in the same room, setting addresses prevents interference.
For how to change addresses of wireless remote controllers, see the operating instructions of wireless / infrared remote
controllers.
To change the receiver’s address, remove the cover from the receiver’s PCB and set No.1 to No.3 of the [003] DIP switch
on PCB.
Remote
Controller
Address
Display
Address Address Address Address Address Address Address
ON/OFF
States
ALL
Position of
the receiver’s
address
switch
Receipt is
possible at
all of the
address
positions
1234
1 2 3 4
1 2 3 4
1 2 3 4
1 234
1 2 3 4
OFF ON
1 2 3456
8-33. CZ-RWSU3, CZ-RWRU3
1. Accessories
Supplied accessories
Wireless Remote
Controller
(1)
(1)
(2)
(2)
(1)
(1)
(1)
Remote Control
Holder
LR03 Size
Battery
Operating
Instructions
Quick
Reference
Wood Screw
M4 × 16
Clamper
(1)
Installation
Instructions
CZ-RWRU3
CZ-RWSU3
8-29
SM830276-00_欧州向け R32シングル TD＆SM.indb 29 19/02/18 11:16:09
To Next Page
Loading...
