88
3. Wiring the Receiver
Wiring Diagram
Sec8.indd17 2012/02/2816:14:02
SM830256-00_Single_欧州小筺体 TD&SM.indb 17 16/12/28 13:40:31
CN001
R1
R2
Receiver PCBIndoor unit
Terminals for RC
wiring
2P white
How to Connect the Wires
• Connect the wires from the receiver to the terminals for RC wiring on the indoor unit. (No polarity)
4. Installing the Receiver
The receiver can be installed only on the corner shown in
Fig. A. Consider the direction where the panel is attached
to the indoor unit.
1
Remove the air inlet grille
Indoor unit electric component box
Installation position for receiver (Fig. A)
Indoor unit electric component box
Air Inlet grille
2
Remove the corner cover
① Remove the screw fixing the corner cover.
Screw
Corner cover
Convex part
② Place a hand on both the right and left convex parts of
the corner cover to remove it.
3
Wire the receiver
① Hang the string of the receiver on the pin of the ceiling panel.
Receiver
Pin
String
② Pass the wiring from the wireless receiver section into the slit.
(See “Wiring for the receiver”)
③ Fix the wiring with the clamper (supplied) while leaving enough
length of wiring to remove the receiver.
Slit
Fix with the clamper (supplied).
(a) Cut this clamper.
4
Fix the receiver
① Fit the receiver to the ceiling panel so the 5 claws are properly
set, and fix it with the removed screw.
• Make sure the wire is not caught.
• When attaching the filter chamber, cut the clamper (a), and
attach the receiver.
Refer to the installation instructions
supplied with the panel.
•
Corner cover
Corner cover
Ceiling panel
Convex part
8-30
SM830276-00_欧州向け R32シングル TD＆SM.indb 30 19/02/18 11:16:10
To Next Page
Loading...
