ER-GB80/ER-GB70/ER-GB60
4
4 Disassembly and Assembly Instructions
4.1. Disassembly Instuctions
1. Remove the attachment and blade.
2. Loosen two screws and remove the blade holder.
3. Press the trimmer driving bar outward. (ER-GB80 and
ER-GB70 only)
4. Loosen a screw on bottom and slide down the bottom
cover.
5. Remove the front panel together with the side panels.
NOTE:
If the front panel is removed alone, it may deform.
6. Remove the switch button.
7. Adjust the trimming height indication mark to the maxi-
mum [10][20] position.
Slide down the dial.
8. Insert a slotted screwdriver to take out the clip on both
side.
To Next Page
Loading...
