6
Mounting the blade
1. Fit the mounting hook into the blade
mounting on the clipper and push in
until it clicks.
Cleaning the blade
1. Brush off any
hairs from the
clipper and from
around the blade.
2. Remove the blade
and brush off the
hairs from the
blade edge.
3. Brush the hairs out
from between the
stationary blade and
the moving blade while
pressing down on the
cleaning lever to raise
the moving blade.
Lubrication
1. Apply a few drops of the oil to the space
between the stationary blade and moving
blade.
Apply the oil to the clipper before and after
each use.
2. Remount the blade on the clipper.
•
To Next Page
Loading...
