Lubrication
1. Apply a few drops of the oil to the space between the
stationary blade and moving blade.
Apply the oil to the clipper before and after each use.
2. Set the dial to “2.0” and then remount the blade on the
clipper.
•
Removing the built‑in rechargeable batteries
1. Remove the blades 1 and four screws 2.
2. Remove the spring 3, the under cover 4, and the blade holder
5.
3. Remove the dial 6 and open the housing 7, and then take out
two batteries 8.
Disconnect the clipper from a household outlet.
Fully discharge the batteries.
Be careful not to short‑circuit the batteries.
To Next Page
Loading...
