Panasonic ES-LV9C - How to Use

11
English
Preparing the cleaning liquid
Cleaning can start right after the usage by preparing in advance.
(See page 13.)
• Remove the AC adaptor from the self‑cleaning recharger.
1
Press the cleaning
liquid unit removal
button (1) and
remove the cleaning
liquid unit (2) on a
hard, at surface.


• When the self‑cleaning recharger is lifted, or on the soft
surface such as carpets, the lock release lever will not t in
the recharger properly. In that case, the cleaning liquid unit
cannot be removed.
2
Pour tap water (1) and
detergent (2) into the
cleaning liquid unit�
• Be careful not to let the
water rise above the
maximum water line (a).
• Pour the entire packet of
detergent.
 

3
Slowly insert the
cleaning liquid unit into
the self-cleaning
recharger until it clicks.
Notes
• To replace the cleaning liquid, see page 17.
• Only use self‑cleaning recharger detergent for Panasonic
shavers.
Not doing so may cause malfunction or failure.
• Do not tilt the self‑cleaning recharger.
Doing so may cause spill or the number of days that cleaning
liquid can be used reduce.
• You can use the cleaning liquid for approximately 30 days if used
once per day.
(This will differ depending on beard thickness and the ambient
temperature.)
How to use
This appliance has a smart lock function, so the power switch is
automatically locked to prevent accidental operation when not shaving.
► Unlocking the power switch
The lamps illuminate upwards
and the power switch is
automatically unlocked when
the main body is grasped.
• The remaining battery capacity
will be shown and then turn off
after approximately 1 second.
► Locking the power switch
The lamps illuminate downwards
and the power switch is
automatically locked 1 minute
after releasing the main body.
• The switch lock lamp ( ) will
light up for 5 seconds and turn off.
ES-LV9C_ASIA.indb 11 2017/09/08 15:21:56