Panasonic ES-LV9C - Page 12

12
English
• The sensor may respond and the power switch may be unlocked
when an electrical device or metal object is brought closer. This
is not abnormal.
Shaving beard
1
Press and shave�
• The “shaving sensor”, which automatically
adjusts the power depending on the beard
thickness, will operate.
It will shave with high power on areas where
the beard is heavy, and reduce the power on
areas where the beard is thin, to reduce
burden on the skin.
Tips for better shaving
Apply the whole system outer foil
perpendicularly against the skin and
shave by slowly gliding the shaver over
the face against the grain of the beard.
• The beard under the chin and around the
throat can be shaved better by stretching
the skin so the beard will stand.
• To prevent damaging the system outer
foil, do not shave with only a part of the
system outer foil.
2
Press when nished.
While using After use
The used time and remaining
battery capacity are shown and
then turn off after 7 seconds.
• The shown time returns to
[0’00”] after 10 minutes.
• The shaving sensor lamp
( ) blinks.
• The charge status lamp ( )
glows and then turn off after
7 seconds when using cord
shaving.
The used time and remaining
battery capacity blink
alternately and then turn off
after 8 seconds.
When the battery capacity is low
“10%” appears and “
” blinks.
The appliance beeps twice after switched off.
• You can shave 1 to 2 times after “10%”
appears. (This will differ depending on usage.)
Notes
• The appliance may not operate in an ambient temperature lower
than approximately 5 °C.
• Depending on the beard thickness or the amount of beard
trimmings in the shaver head, the shaving sensor may not react
and the driving sound may not change. This is not abnormal.
• To prevent erroneous operation, place your ngers on the nger
rest while using the shaver.
ES-LV9C_ASIA.indb 12 2017/09/08 15:21:56