Panasonic ES2045 - Operating Your Epilator; Pre-Operation Safety Check & Wet Epilation

trolled, the life of the batteries
does not deteriorate. There is
generally a memory effect whereby
the voltage will be reduced if the
appliance is repeatedly charged
and discharged without completely
using the capacity of the batteries.
If the appliance is used until no
charge remains in the battery and
then charged for 20 hours, this
effect will disappear.
* Please use the charger provided
to charge the battery.
* Please charge and use the appli-
ance at a temperature of between
5~40°C (41°~104°F).
* lt is perfectly normal for the
appliance to become slightly warm
when being charged or used.
* If the cord becomes damaged it
is not possible to replace only the
cord. Please contact your nearest
dealer or Panasonic Customer
Service Center.
NOTE: The appliance will not
charge if the switch is in any
position other than O-charge.
Always check to see that the
charging light is on.
How to operate your
epilator
CAUTION: Always make sure
that the epilation discs and
skin protector have not become
damaged, cracked or deformed. If
they are, then please do not use
the appliance.
Failure to do so can cause damage
to the skin.
Wet epilation
* Remove the cap.
* Attach the head you wish to use.
* Place a small quantity of liquid
body soap on the discs.
* Wet the discs.
* Slide the switch to 1 or 2 position
and carry out epilation.
NOTE: Allow the discs to spin and
foam up the soap.
Always use liquid body soap when
carrying out epilation. Using just
cold or warm water without soap
will hinder the movement of the
epilator.
Please see “Use foam to achieve
the best results” for details.
Always wash the discs well after
use to remove any residual soap.
NOTE: If soap is left on the
discs then a white deposit can
accumulate and prevent the
blades from moving smoothly.
Use the supplied brush to remove
any remaining hair.
After epilation slide the switch to
the O-charge position.
NOTE: Remove any dirt with a
dry cloth and allow the appliance
to dry thoroughly. Leaving the
appliance wet for long periods of
time can cause malodor.
Use foam to achieve the best
results
Apply sufficient foam.
NOTE: The foam guides the hair into
the discs. If there is insufficient
foam, then there is the possibility
that the hair may not be removed,
making it difficult to properly carry