5
English
Charging with the self-cleaning recharger
Thoroughly wipe off any drops of water on or around the recharger so that it is dry before charging it.
You can charge without the recharger.
Page 6
Charge
Attach the detergent
cartridge and the
water tank to the
self-cleaning
recharger.
Page 7
Insert the appliance
plug.
Plug in the adaptor.
Pull up the arm until it
clicks.
Remove the protective
cap and then attach
the shaver.
• Turn the shaver off before
attaching.
• Check that the outer foil is not
deformed or damaged when you
are attaching the shaver.
Push down the arm
until it clicks.
• The charge status lamp glows
and charging starts.
• Charging is completed when the
charge status lamp blinks.
(Max. 1 hour later)
• You can keep the shaver attached to the recharger, or
connected to the adaptor, when not using it to maintain full
battery capacity. You cannot overcharge the shaver.
• A special plug adaptor may be required in some areas.
To Next Page
Loading...
