39
DISPOSAL OF THE
PRODUCT (Fig. 12)
The power source of this
product is nickel-metal hydride
battery which can be recycled.
Please dispose of the device
and the battery in accordance
with national or public
regulations or environmental
protection or recycling
regulations.
WARNING:
Do not disassemble the product
at any time other than when
disposing of it. Failure to
observe this point may result in
short circuit, fire, or injury.
For repair or maintenance (such
as battery replacement), take
the product to an authorised
service centre.
Removing the Ni-MH battery
before disposing of the product
Before removing the battery,
be sure to completely drain the
unit of power.
Use a screwdriver to
disassemble the unit to
dispose of the battery. Remove
,
2
,
3
and
4
,
5
.
Pressing the toothbrush shaft
(see page
2), remove the two
hooks
6
. Remove the
7
and
8
as sho
wn in Fig. 12.
•
•
Be careful not to short-circuit
the negative and positive poles
of the battery.
SPECIFICATIONS
Rated voltage:
100-240 V AC
(110 - 120 V AC for Taiwan)
50 - 60 Hz
Battery:
1 Ni-MH batter
y (1.2 V DC;
1,100 mAh)
Charging time: 15 hours
Input current: 35 mA
Power consumption:
2
W (when fully charged)
Brush rotating speed:
appro
x. 26,000 strokes/min.
(with no load)
Brush movement width:
approx. 0.8 mm
Operating time:
appro
x. 40 minutes of
continuous use (with 300
g
load at a room temperature of
20°C after the battery has
been fully charged.)
Dimensions:
Main unit: 24 - 27 (diameter)
1
69 (length) mm
Charger: 85 (H)
46
(W)
90 (D) mm
Weight:
Main unit:
110 g
Charger
: 145 g
Household use only
•
To Next Page
Loading...
