Panasonic EY6220 - Page 4

(Motor Removal/Replacement)
1. Slowly remove motor with switch from gear-box block.
Note. When removing, the gears may come out. Grasp the
both ends {§) of the motor to prevent this
(Fig. 6)
If the internal divider come off, replace it into gear-box block
accordingly as shown to keep the gears from falling out
(Fig 7)
<8>
Gear box
Motor
2
When connecting the motor to gear-box block, slowly insert the
motor gear twisting slightly into the gear-box block for proper match
(Fig 8)
(Switch Removal/Replacement)
1 Remove switch from motor
Note When connecting the switch to the motor, be sure to check
the direction as shown If connect incorrectly, it is impossible
to replace them into the housings
Connect the switch firmly to the motor as far as it will go
(Fig 9)
(Clutch Assembly/Disassembly)
Note To disassemble the clutch, first disassemble the housings
and grip block
1 Remove the clutch handle
2. Unscrew the adjust ring, and remove it
Note - Be careful not to lose the clutch pins and steel balls.
3 When reassembling, screw the adjust ring so far as the surfaces
of adjust ring and gear-box top,come to the same surface level
(Fig.10)
By this, one of the projection (A) of adjust ring come to the po¬
sition as shown
4, Replace the clutch handle fitting the groove B to the projection A.
(Fig. 11)
(Fig