Panasonic F10 MARK II - Page 22

CONNECTION
OF
ENG
APPLICATIONS
OPERATING
PROCEDURE
FOR
ENG
APPLICATION
CAUTION
:
Keep
the
power
switch
on
the
camera
and
VTR
in
1.
Set
the
VTR
Compatibility
Switch
(RUN,
@/@)
to
@
the
OFF
position
during
connection.
position
for
Panasonic
VHS
VTRs,
3/4’
VTR
or
S-VHS
VTR after detaching the Cheek Pad (50) by loosening the
1. Connect the camera cable between the camera and the Cheek Pad Lock Screw (52) and then re-install the Cheek
Panasonic portable VTR (Standard camera cabie length is Pad.
2m.).
2. Do not feed out the video signal from 10-pin VTR connec-
tor (28) and 14-pin VTR connector (31) at same time.
3. When the Gen-lock Adaptor (WV-AD36E) or the RCU
Adaptor (WV-AD37E) is installed on the camera, supply
the power to the camera from these adaptors. Do not
supply the power from the camera.
2. Remove the Jens cap.
3. Set the DC Power Selection Switch (27) to either 10P or
14P.
DC POWER
EXT 10P 14P
Note: The distance between the camera and the power
supplying product should be less than 10m.
ee by ee