6-12
Location Procedure
Check
1
(1) Open the front door.
(2) When using the exit tray, remove
the exit tray.
(3) Open the exit cover.
(2) Installation
Remove all shipping materials before installation.
Caution: Make sure the copier is unplugged before the installation.
2
(1) Remove the left cover. (3 screws)
(2) Remove the rear cover. (7 screws)
3
Remove the power cord mounting
bracket. (2 screws)
4
(1) Remove the lower cassette rail
fixing screw. (rear side X 1)
(2) Install the sorter receiving bracket
(rear).
(1 screw: just removed,
1 screw: included)
(3) Reinstall the power cord mounting
bracket. (2 screws removed)
1
2
Sorter receiving
bracket (rear)
Left cover
1
2
3
Power cord mounting bracket
To Next Page
Loading...
