11
CAUTION
WARNING
Disconnect power source before working on unit.
Routine maintenance must be done every year.
Please wear gloves during the cleaning work.
Never use gasoline, benzene, thinner or any other
such chemicals for cleaning the ventilating fan.
Do not immerse motor in water when cleaning.
Do not soak resin parts in water over 140°F (60°C).
MAINTENANCE (CLEANING)
Do not use cleaning sprays, solvents, or water on
or near the sensors.
English
2. Clean grille. (Don’t put into hot water. Use
non-abrasive kitchen detergent, wipe dry with
clean cloth) (Fig.16)
3. The grille should be dry after cleaning.
4. Remove dust and dirt from fan body using a
vacuum cleaner. (Fig.17)
5. Using a cloth dampened with kitchen detergent,
remove any dirt from fan body. Wipe dry with
clean cloth. (Fig.18)
6. Reinstall grille.
1. Remove grille by pulling down one mounting
spring (Fig.14), then pull down the other. (Pull
down the mounting spring that without lead wire
passed side, and remove motion sensor as
shown in Fig.15) (Squeeze mounting spring and
pull down carefully)
Fig.16
Gloves
Mounting spring
Gloves
Slot
Grille
Fig.14
Fig.15
Ceiling
Clasp
Ceiling
Vacuum
cleaner
Ceiling
Fig.17
Fig.18
Gloves
To Next Page
Loading...
