computer doesn't light; Shutdown, Hibernation and while the AC adaptor is connected to the computer.
In the case of a hot swap, finish replacing the battery within a minute. Depending on the built-in bridge
battery status, the computer may enter hibernation within one minute. Replace the battery
pack as
so
on as possible.
If you start a hot swap with the AC adaptor connected, do not disconnect the AC adaptor until the
battery pack has
been replaced. If you unplug the AC adaptor, even if Built-in Bridge Battery
is
charged, the compute
r will turn off.
To insert
Close the battery pack until it touch to the secured position.
Be careful about the battery pack direction.
In case that the projection does not match the dents of the computer, detach the battery pack once, then slide it while
pushing it lightly to avoid floating.
<Only for model with Built-in Bridge Battery>
I
f the built-in bridge battery has not enough remaining power, you cannot replace the battery pack without turning off
the computer.
Turn off your computer before replacing the battery pack.
Make sure the latch is securely locked, otherwise the battery pack may fall when you carry the computer.
Do not remove the battery pack forcibly when the latches are locked. Doing so may damage the battery pack.
CAUTIO
To Previous Page
Loading...
